MikroTik RB4011 vs TP-Link ER605

I have used ED with regards to based routers in the past as a way to have a feature rich device on lower price range. Experience was not that good. Fi...

Alright, so let's go ahead and talk about the physical differences between the two hardware versions, V1 and V2. Of course on the front face here, the...

A mikrotik rb4011 might be up your alley if you're fine doing the config. They're extremely reliable, moreso than what's available from manufacturers like Asus and Netgear.

Now let's put the Globe cable back. It's back online in around 20 seconds. Well, it's safe to say that it takes around 20-30 seconds for the modems to...

Once it got setup, it was blazing fast. Pros: Super fast routing. You will get as much mbps as your ISP will allow in your plan. High performance 1G ports that offer flexible vlan switching and segmentation

This router has performed well with occasional glitches: timeouts on IP assignments through my AP (also Tp-link), fairly regular IP assigned with wireless that work fine locally, but report (correctly) they can't reach the internet where no issue is apparent in logs of this router or the AP. Customer service is responsive, but resolution of the failed DHCP issue required turning all optimization parameters off, while only using one, but improved. Biggest concern is hardware change and TP-link has done this before: V2 has substantially better hardware specs but the only way to know is manual comparison of data sheets. Since IPV6 support was promised, then apparently had a soft rollout, customers and customer support had to ask to find out, while some newer versions were offered and old version received

) If you're not a pro, or at least someone with extensive network management expertise, you might wish to consider something with an easier management interface. The basic configuration was simple enough. But I wanted to set up WAN failover. And I wanted to set up basic security stuff, including setting it to disable pings and connection attempts from the WAN side

TP-Link ER605 | Multi-WAN Wired VPN Router | Up to 4 Gigabit WAN Ports | SPI Firewall SMB Router | Omada SDN Integrated | Load Balance | Lightning Protection | Limited Lifetime Protection.

I have been using this new Mikrotik RB4011 for a month now, and it was a much needed upgrade. I have Spectrum 100/10Mbps internet service a my old router did not have the CPU power that this one dose, so no more slow speedtests. I am now seeing consistent higher than advertised results. I have also noticed that pings in online games are lower and website page loads are faster

The result? Well my top speed capped out at just over 600MBs down and 830MBs up. Now I do believe that is due to some other configurations that I have in place. The Omada app, is a joke. The limitations of the Omada app compared to the web interface is a night and day difference, and not in a good way

With rugged metal construction and cooling bits, this unit is built to last for years over reliable 24x7 service. Overall, the Microtech RB4011 Gigabi...

For just a one bedroom apartment, if go with the TP-Link ER605 as your router and then a TP-Link EAP225 for your access point. This will easily fit in your budget, give you rock-solid performance, and is no problem to upgrade or expand if you move.

Reasonably straightforward to set up. Router does its job well. Definite value for money. Take note that it gets warm, built in heat sink take care of it

I WFH full time now and Comcast has cost me several days work so I got a 5G backup and needed a way to connect both of them. This has done a great job, wasn't hard to set up, and has a bunch of features that I'm not using if I want to geek out later.