Creality CR-10

All of these people have the CR 10 printer, and all of them would be more than happy to sell it to you. I hope you found this enjoyable. I hope you fo...

Basically, this was my experience after buying the printer.

It was inevitable that the model would be knocked clear.

I've tried to drop the flow rate, but it comes out exactly the same each time - nice printed bottom layers, but fuzzy when the vase mode section kicks in. I'm currently drying the PETg, but thought it was odd that it starts off fine. I don't have the fuzzy setting enabled (I checked multiple times). Sliced in Cura, printed on a modded CR-10.

I will come back and update this review as time passes but I'll start off with what I know so far. I am in the process of returning my first unit and the replacement is on the way, should arrive tomorrow. The problem with the first unit is that during a print the model lost it's adhesion and a blob ...

Check out the Sovol SV01; pretty much a CR-10 but about half the price (country dependent). Direct drive extruder, large bed and pretty much ready to go out of the box.

Straight out of the box, the Z stop switch once mounted was way too low for the machine to stop. The holes for the screws were drilled in the wrong places. This resulted in the stepper motor trying to drive itself through the bed. I had to drill new holes in that part so i could get it high enough f...

4 Ender 3, 4 CR-10, 2 Anycubic Chiron, 2 Photon S, 1 Photon Mono, 1 Photon Zero, 1 Elegoo Mars

Not a business, I just like printers

I've read people singing praises for this machine so, I went and got myself one. I printed a sample that came out fine, then went to print something from thingaverse dot com. As it turns out, my printer doesn't want the z axis to go above the small print I had successfully printed. When I tried to p...

You should try other slicer software like prusaslicer or cura as they have more features than the software provided by creality. My first printer was a creality cr-10 v2 and the software provided in the flash drive was corrupted so I just started using prusa slicer and that was way better. I did try again and did use creality slicer but it wasn’t as good and had tons of bugs.