Lian Li PC-O11 Air Mini

And so in the end of the day the O11 Air Mini structure wise I feel like is a much better upgrade versus the previous O11 Dynamic Mini basically givin...

So the feature set isn't anywhere close to what the O11 Air Mini here is offering and the H510 Flow ended up just being a lazy refresh of a case by NZ...

This case is great if you're looking for a smaller case for a full ATX motherboard with *just* enough room for components, but unfortunately, quality control leaves a lot to be desired. The most egregious is the broken 120mm case fan, where the fan blades completely fell out of their housing. I thou...

If it was like 3/4” deeper in the back it would be better. Overall it’s great but just don’t try to have excess stuff like Corsair lighting components. It will get hella tight quickly

Purchased this case about two months ago and have been very satisfied with it. For owners of massive GPUs, you'll be pleased to know that the advertised 362mm length limit is measured with the front fans installed. This is important because sometimes case manufacturers will remove the fans before ta...

This is my first Lian Li case, and I'm blown away by the thoughtful design, high quality of materials, and their commitment to easing your install. There are some caveats that are important to know when planning out airflow, which I'll go in to below. Positives -High quality materials and design -Th...

Really enjoyed this case and build. There's plenty of room and lots of fan locations, lots of flexibility with building. Fan configuration: Used 2 Lian Li 140mm UNI fans on the top, on the front, and on the bottom. Stock rear fan. I built a full ATX system with a Noctua NH-D15S air cooler. It is BIG...

I had high expectations going in, with this case. I was using MSI 100R case, which has less air flow but really good looks. I didn't notice any big improvement over the MSI's case; however, if I need to do it all over again, I will pick this case (as I do a bit of gaming) over MSI's case. MSI's case...

I really like the idea of dual chamber cases and mostly of them are maded by Lian Li with a few corsair cases, the case itself is very good, however they're things that they should have been fixed a long time ago with the perfored panels way back: The HDD drive cage in top of the psu is riveted and ...

The media could not be loaded. Reporting an issue I had with my build, the pre-cut rear fan mounting slots on the lian li o11 mini-1 vertical gpu bracket didn’t offer enough clearance for the stock 120mm fan to be installed with a large graphic card at the bottom, It won’t fit. I drilled 4 holes at ...