Ruckus Unleashed vs TP-Link Deco X60 AX3000

Ruckus stuff just works. Unleashed can be configured from a web browser without java, unlike ubiquiti.

Now they cover up to 650m2 home, they also are compatible with the Amazon Alexa device, so they will work with that and extremely easy to set up as I ...

Compared to other products, I'd say Ruckus' strength lies in their actual radio tech and the client connectivity experience (BeamFlex+, ChannelFly, etc.), as opposed to having slick software (ie. UniFi) or a more polished vertical hardware stack (HPE Aruba, Meraki). So putting aside fancier dashboards and cloud control panels, Ruckus is tough to beat when it comes to providing the best physical connection possible in *most* scenarios

Just a little further out it drops below 200. Signal is strong and hasn't dropped internet over the past few days. At the far end of the house I have the second unit setup and getting 100-150 mbps. Haven't had to use the 3rd unit yet

I'm pretty sure their tech support just enjoys stringing people along for as long as possible for their own amusement. If WiFi calling from your cell phone through your access point is an import feature, do not buy these! UPDATE: I'm now up to 20 messages back and forth, and finally got contacted by an engineer. He verified these units do not support WiFi Calling. He said WiFi Calling is supposed to be enabled on the next firmware version, 200

Power everything down, reconnect everything as it was before (my original router, AP, etc). Right back where I started, which is going to have to do for now. My time is too valuable to spend messing around with a system that purports to work right out of the box but completely fails to do so. I don't want to paint with too broad a brush, but I have to say that I've never been overjoyed with any tp-link product that I have purchased

Some of you might be wondering why you are here. I'm putting together a special team. Your top dogs. Our customers deserve the fastest wireless networ...

Update #3: Success, FINALLY! Critical step to get this mesh system to work: Once installed, go to the Deco app -> Settings -> Advanced -> IPv6 -> Enable -> Reboot the Deco system [Ignore the following step if you're setting up for the first time] Then, "Forget Network" on all your devices that had been on this Deco Mesh network, then re-add all your devices to Deco Network, then restart all your devices (unplug, wait 30-sec, plug in and restart.) Lastly, confirm IPv6 is enabled in Deco app (same steps as above.) Check speeds with your phone or laptop using Speedtest or Fast(dot)com The steps above finally resolved the random disconnects and slowness, including my slow connections for web TVs. The connection speed is at least 10x higher and Netflix loads much quicker and with HD or 4k resolution! I was literally going to Factory Reset the Deco system and return it