Racor Solo Vertical Bike Rack

This is a great concept, and it is a great combination of aesthetically pleasing and cost effective, but the quality gives me pause in recommending others to purchase. The good: - Inexpensive - Fits a wide range of bikes, including a mountain bike with 2" tires and standard road bike tires - Looks n...

I purchased this product along with aDelta Da Vinci Bicycle Tire Tray and I recommend you purchase the tire tray as well if you want to reduce wall scuffs. The install of this rack in my apartment was straight forward but only because I have a stud finder in my toolbox and that allowed me to accurat...

I installed two of these on a 3 foot piece of pine 2X10. The width of the board just fit the bicycle mount. Mounting was simple, only two screws, and it held the bikes well. Since the bottom wheel is not secured the bike will usually not hang straight down, but it can be easily set that way. The rea...

I purchased 4 of these mounts and installed them on 1/2" 2 ft. x 8 ft. plywood sheet over drywall. This enabled placement of the mounts irrespective of stud spacing. I used the included screws and did not experience issue others had with screws breaking off/stripping out - but I only had 1/2" of woo...

If I could give 4.5 stars, I would; here's why I'm dinging a star... This provides perfect spacing to line up several bikes. Some caution has to be paid when hanging your bike to make sure you're not hanging with pressure on a spoke. Install is super easy, and it had no trouble holding a 37lb vintag...

I bought two of these to try out in my storage bay/ warehouse. I needed an easy way to store my growing collection of bikes out of the way (the rack is attached about 12 feet high). This rack worked perfectly! A lot of reviewers have complained about the quality of the screws the rack comes with, I ...

It does its job, but not without some major issues. First, my bike. 25lb full suspension mountain bike with a lightweight DT Swiss alloy wheelset (XR 1450). Nothing crazy or custom, but high end and not cheap. 25lbs is quite light for a mountain bike too. Tires are 26" x 2.4" wide, and they fit with...

The product is made in China but it still functions as it should. The welding was in good shape. The rubberized coating for the wheel rim slides on and off so I put a little glue on the arm and slid the rubber back over it. It stays in place now. I like the snap on plate to cover the two screws but ...

It didn't work quite as well as I'd hoped - the bike sways back and forth a little, as there isn't anything to keep it from doing that - maybe if the two bumps were a little larger, that would be better. It does use quite a bit of force on the wall, and the first time I installed it (on an outside w...

This is one of the few, maybe only, bike wall mount hooks that has the opening on the left side. I have a similar bike hook on another wall where the opening is on the right and that's great because it's near a corner with a short wall on the opposite side. My other bike I planned on hanging alongsi...