Elegoo Neptune 2S vs Flashforge Creator Pro

It took me several trips around the four outside spots before I had them all at the right level. When I went to check spot five in the middle, I found it was way too high - the nozzle was hitting the build plate. I adjusted each of the four corners down identical amounts until the center was the correct height. I reasoned that the prints would be in the middle, so lets make sure this printer works before exploring my warranty options - more on that in a bit

I also see a lot of people reccomend the Prusia mk3s. OP, these are great printers but I want you to understand what you are paying for when you buy the printer. The I3 (bedflinger) design is one of the cheapest designs on the market and a Prusia mk3s probably costs about $500-$600 (US) in parts but the rest of the cost is people checking all the electrical components to see if they function properly, research and development into new iterations and for extensive, high quality customer support. If you buy the prebuilt then you will also be paying for someone to put the printer together and run a ~2 hour test print to make sure the thing works