Biqu B1 vs Elegoo Mars 2 Pro

I haven't tried this on anything other than pla, but the print sticks great, and then it comes off easier than anything. I'Ve personally tried before ...

Hello, everybody welcome back to my shop. The resin printer market is full of competition, saying that their machine is the best but who's to say for ...

Ultimately, having gone the Ender route, I fear nothing in 3D printing land. I've stared into the abyss of nozzle crashes, wrestled the frame back into square after an ugly end-stop fail, and battled the BLTouch into submission with mighty firmware hacks. I've upgraded the hell out of it and it's now almost as reliable and consistent as my MK3S and still not as expensive.

Secondly, my rubber seal lasted just about two prints. Before i threw it away, i found it dragged against the tri-clamps, pulling free and taking unwa...

I keep it around 60mm/s and I rarely have a failed print caused by the machine (pobody's nerfect). The touchscreen makes the interface so much easier, the print quality is phenomenal for the price point, and I haven't had a single clog yet (I also don't try to see if I can get the guide wheels to smoke). I've done a bit of PETG on it, but I don't really do nylons and infused filaments so I can't speak to its tolerances there.I haven't really done any upgrades to it besides using RPi with Octoprint and it runs like a dream

My kids school was going to throw away 2 MP10's and a Elegoo Mars Pro resin printer. Their teacher gave them to me for free with about $100 worth of resin, and a "have fun!". After a LCD screen, a good cleaning, tightening, and a bed level, I now have 3 perfectly working printers to compliment my Anycubic's. $17 bucks, it's work every penny

Just moves the print head off to the side, pauses the print and waits for you to retract and then reinsert some new filament, at which point you can j...

For 3D printers, I would recommend an Elegoo Mars (any in the series). They are inexpensive, easy to use, and achieve really great detail with little effort. This is my go-to printer, and is the one I tried making my maker's mark stamps on. Great printer