Artillery Hornet vs Elegoo Neptune 2S

You want to be safe with power, right? You bet. I asked about the firmware and Tracy over at Artillery thankfully was able to send it to me in a zip f...

It took me several trips around the four outside spots before I had them all at the right level. When I went to check spot five in the middle, I found it was way too high - the nozzle was hitting the build plate. I adjusted each of the four corners down identical amounts until the center was the correct height. I reasoned that the prints would be in the middle, so lets make sure this printer works before exploring my warranty options - more on that in a bit